< Condensed Milk Processing Machinery & Equipment Supplier|Techgen Engineering Ltd.

Condensed Milk Production Line:

Under the flow chart below shows a process line for sweetened condensed milk manufactured from fresh milk. Before evaporation, the fat and solids-non-fat values of the milk have been standardized to pre determined. The milk has also been heat treated to destroy micro-organisms and enzymes which could cause problems and to stabilize the protein complex. Heat treatment is also important to the development of product viscosity during storage, and is particularly important in the case of sweetened condensed milk. The addition of sugar is a key step in the manufacture of sweetened condensed milk, as the shelf life of the product depends on its osmotic pressure being sufficiently high. A sugar content of at least 62.5% in the aqueous phase is required. Two methods are used for addition of sugar:

  • Addition of dry sugar before heat treatment
  • Addition of sugar syrup in the evaporator
complete condensed milk production machinery

The stage at which the sugar is added affects the viscosity of the end product. The evaporator is usually of the multistage falling-film type. When sugar is added in the evaporator, the syrup is drawn into the evaporator and mixed with the milk at the half-way stage of the process. Evaporation then continues until the required dry matter content has been reached. The dry matter content is checked continuously by determining the density of the concentrate.


Sweetened condensed milk must be cooled after evaporation. This is the most critical and important stage in the whole process. The water in the condensed milk can only hold half the quantity of lactose in solution. The remaining half will therefore be precipitated in the form of crystals. If the surplus lactose is allowed to precipitate freely, the sugar crystals will be large and the product will be gritty and unsuitable for many applications. It is consequently preferable to control the crystallization of lactose so that very small crystals are obtained. The required crystallization is accomplished by cooling the mixture rapidly under vigorous agitation, without air being entrapped. The cooled condensed milk is pumped to a storage tank where it is kept until the following day to allow the crystallization process to be completed.


Sweetened condensed milk should be yellowish in color and have the appearance of mayonnaise. Traditionally, it is packed in cans, which in this case must be cleaned and sterilized before filling as no sterilization takes place after canning. Nowadays it is also possible to pack sweetened condensed milk in aseptic paperboard packages. The product is also packed in big barrels, holding about 300kg, for supply to large-scale users.

Flow-Chart:

complete butter production line flow chart

Machinery Diagram of Condensed Milk Plant:

complete Condensed Milk production line flow diagram

BENEFIT

  1. Recording, visualization and printing of all daily production data.
  2. Complete line supervision system through monitoring of every process phase.
  3. Highest energy savings thanks to the most advanced technologies.
  4. Maximum yield, minimum production waste.
  5. Wide customization of the final product.
  6. Opportunity to produce more than one product with the same processing line.
  7. Opportunity to realize products with customized recipes.

"If you are Interested our Product or any Information, don't hesitate to contact us."

Click Here To Contact

©copyrights @ Techgen Engineering Ltd. All Rights Reserved

Designed By: Kutub


*****Up to date technology assured*****